How Do You Fix A Kawasaki KLX 125 Throttle Cable

When asking how do you fix a Kawasaki KLX 125 throttle cable, safety questions pop into our minds. Prevention should always be taken in account when handling repairs. If you’re using your bike very often without performing proper maintenance, one day the throttle cable won’t work the way it must. No matter the situation, apply these useful tips to solve any arising issues.

To fix a Kawasaki KLX 125 throttle cable, you will need:

  • Adjustable spanner
  • Screw driver
  • New Throttle Cable
  • Wrench
  • Lubrication
  1. The Bowden Cable. For any type of bike that uses a throttle cable, this is the right name for that item. It is the one responsible for the transmission of mechanical pulling force in your Kawasaki KLX 125 bike. This is done thanks to the inner cable made of steel and covered with a sheath of plastic. The cable adjuster will allow you to regulate the cable throttle length and tension, as well as giving way for an anchor point to hold it steady in your engine control.
  2. Possible Failures. Just like any kind of material, the throttle cable has a life cycle. By using it more than usual for engine control, cable fraying can become a problem. Even under these circumstances, if the cable is too tight, it will eventually break. Without good lubrication to the housing, the transmission could also be in danger. Nevertheless, the Kawasaki KLX 125 comes with a very resistant throttle cable, which will minimize the times it will need to be replaced.
  3. Testing The Cable. An easy way to check the throttle cable right away is to pull it carefully, not using too much force. Pay attention, as the cable in your Kawasaki KLX 125 needs to return to its original position, just to make sure it is working fine. If the throttle cable doesn't return smoothly,  it’s time to fix it.
  4. Fixing The Cable. First, look for the adjustment screw, so as to know where to loosen or tighten the throttle cable. Take off the switch housing. Here, you can add some lube to the cable. Then, reattach the switch housing. The cable should slide more smoothly than before.    
  5. Replace The Cable. All the easy steps above should be enough, but if you want to change the whole throttle cable of your Kawasaki KLX 125, first remove the housing cap at the handle bars. Grab the cable end and take it up of the housing. Look for the other side of the cable in the carburetor. Here is where there is a bike throttle control housing. You need to gently take the new cable into the sliding end. Put the screws again and follow the cable route up through the bike’s frame, and right into the handle bars. Unscrew and screw again all the cable connections for optimum engine control.

That’s it. Now, it's time to test your bike!

show comments

What Others Are Reading Right Now.