How To Get Wrinkles Out Of Polyester

Polyester is a common type of fabric that is tough and sturdy, so it is useful to know how to get wrinkles out of polyester. Unfortunately,it can be hard to care for, especially when it comes to removing wrinkles. One of the best ways to get wrinkles out of polyester is to wash it before applying any type of heat. When the garment is clean, try these simple techniques below to rid your polyester clothing from unappealing wrinkles.

1. Wash the garment thoroughly. Machine wash the garment with warm water using all-purpose detergent. Having a clean garment will reduce the amount of time it takes to get wrinkles out of polyester later on.
2. Place the garment in a dryer on a low to medium setting. Tumble dry. Do not over heat the garment or place it on a high setting as this could shrink and wrinkle the garment even further, making it harder to get wrinkles out of polyester.
3. Iron the polyester. First turn the garment inside out, laying the garment on a clean ironing board. Iron polyester clothing on the inside (or the wrong side) to prevent the outer side (the right side) from getting ugly iron marks. Place the iron on a low setting. Begin ironing the top part, working your way down to the garment’s bottom part; add a little pressure to the iron to allow the heat to seep through, making it easier to knock out wrinkles more efficiently.  Press down firmly when you get to wrinkles that are more visible and more difficult to remove. Repeat process at least three to four times, alternating from the front to the back sides of the garment to get wrinkles out of polyester.
4. Another way to get wrinkles out of polyester clothing is to steam your garment. Draw a hot bath and hang the garment over the hot steaming water for one to two hours, allowing the steam to let the wrinkles fall out on its own. Purchase a clothing streamer to get the same results. Using a garment steamer will relax the fibers in clothing rather than crush them as an iron would. Constant iron use on polyester material can over flatten its fibers, resulting in weakened material that overtime, will rip and tear.