How To Install A Car Amplifier In A Monte Carlo

 

Do you want to learn how to install a car amplifier in a Monte Carlo? You decided to do a small upgrade to the sound system in your Monte Carlo but have no idea how to install the amplifier. You thought in these tough times it's better to look up how to install a an amplifier in a Monte Carlo online and found this simple guide.

To install a car amplifier in a Monte Carlo, you will need:

  • amplifier
  • wire cutters
  • screwdrivers
  • wiring
  1. The first step to installing an amplifier in your Monte Carlo is to disconnect your battery. After you have done that, run the power cable for the amplifier from the battery to where you want your amplifier.

  2. The second step to installing an amplifier in your Monte Carlo is to find a metal screw or bolt. Once you have found a metal screw or bolt, connect the ground to it.

  3. The third step to installing an amplifier in your Monte Carlo is remove your head unit. After you have removed your head unit, run the signal and remote wires to your head unit.

  4. The fourth and final step to installing an amplifier in your Monte Carlo is to screw down your amplifier then reconnect your battery. Now turn on your radio and make sure the amplifier works. After you have it on and running put everything back together. Congratulations, you now know how to install an amplifier in your Monte Carlo.

Tips:

  • If your amplifier will not work, check the ground.

  • Do not have your speaker or signal wires run near your amplifiers power cables or else it will cause interference.

show comments

What Others Are Reading Right Now.