How To Install A Kenwood DPX-MP4070

Looking for how to install a Kenwood DPX-MP4070? Bought a Kenwood DPX-MP4070 and need help installing it? Were the instructions that came with the radio not clear or too complicated? Do you just need to see another point of view on installing your Kenwood DPX-MP4070? Look no further! You have found a guide that is about installing the Kenwood DPX-MP4070. Before you get started, you are going to need some materials.

The materials needed are:

  • Dash Kit (Make sure it is big enough to house your Kenwood DPX-MP4070.)

  • Wire cutter

  • Wedge

  • Wrench 1/2

  1. The first step is to go inside your car and eject any CD's from your old radio. You should also write down your favorite radio stations if you do not have them memorized already. After you have done that, open up the hood of your car. Take your wrench and unbolt the nuts on the bracket that is connecting the battery to your car.

  2. After you have done that, take your wedge and slowly pry out your radio. The next thing is to take your wire cutters and cut all the wires.

  3. Once you have done that, the next step to installing a Kenwood DPX-MP4070 is to install the dash kit. This is done by slowly inserting the kit till you hear a click. Once you hear a click, reach down and pull out the wires. Now connect the wires to your Kenwood DPX-MP4070. The wires are color coded so all you need to do is connect red to red and so forth. Insert the radio into the slot and congratulations, you know how to install a Kenwood DPX-MP4070.

show comments

What Others Are Reading Right Now.