How To Install Vintage Car Stereo

Do you need to know how to install a vintage car stereo? Then grab the materials listed later in this paragraph and print out this article. You have found the ultimate guide to learning how to install a vintage car stereo. Before you get started, make sure your vintage car stereo works. This can be done by taking it to your nearest auto specialty store and have them run some test on it. After all why waste your valuable time installing a vintage car stereo when it does not even work.

To install a vintage car stereo, you will need:

  • vintage stereo

  • flathead screw driver

  • wire cutters

  • Wrench

  1. The first to installing a vintage car stereo is to disconnect the battery from the car. This done by taking your wrench and unscrewing the bold to remove the cables from the battery. Make sure to take down notes of your favorite radio stations with the radio in the car now. Also make sure to eject any CDs or tapes. Once the battery is disconnected you will not be able to do this. You will also not be able to remove the CDs after the vintage car stereo is installed.

  2. The second step to installing a vintage car stereo is to go inside the car and use the flat head screw driver to pry the old radio out of the dash. After you have done that, cut the wires.

  3. The third and final step to installing a vintage car stereo is to reconnect the stereo wires to your vintage car stereo and carefully insert it into the dash. Reconnect the battery. You now know how to install a vintage car stereo.

show comments

What Others Are Reading Right Now.