How To Solder Brass Instruments

Here are instructions for how to solder brass instruments. While many may think it’s going to be hard to do, the good news is it’s not as hard as most think.

To solder a brass instrument, you will need:

  • Brass Soldering Wire
  • Soldering gun with temp control
  • Clean work surface
  1. Get the Right Soldering Tools. The tools you use are going to be a big aspect of soldering something like a brass instrument. If you do not have the right soldering wire or the right temperature soldering tool, you won’t be able to get it to work. The proper gauge of brass wire can be found at an Instrument repair outlet. A good soldering gun is also something that is needed when starting to solder brass instruments. These can be found at any local hardware store. When getting a soldering gun, you will want to make sure it has more than one temperature.
  2. Heat Up the Soldering Gun. The next step for how to solder brass instruments is to heat up the soldering gun. Make sure it is not in an area that will start a fire while it’s heating up, which is usually only a couple of minutes.
  3. Unroll Some of the Wire. The third step in soldering brass instruments is to unroll some of the wire. This way, the user will have the wire you need for the solder ready to go. You can lay it out on the table so it’s ready to work with.
  4. Put the Broken Parts Together. Make sure the broken parts are put back together properly. Doing so will ensure the solder will properly fix the instrument and will make it look as though there was never a break in the first place.
  5. Solder the Parts Together. The final step for how to solder brass instruments is to actually solder the parts together. Place the soldering gun close to the brass wire and the broken area of the instrument. Then, heat up the wire until it starts to melt onto the instrument. Do this on both sides of the break and let it cool down. The break should now be fixed.

Knowing how to solder brass instruments is going to be extremely helpful to any musician.  You should take your time and do the soldering right, so it doesn’t have to be done again.

show comments

What Others Are Reading Right Now.